Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge
modelling Week 5 & 6 Challenge
Aim:
- Route two electrical harnesses per the given layout and interconnect them as a single harness assembly
- check for bundle continuity, and bundle warnings, and then provide annotations for the final harness assembly.
Objective:
- The objective of this project is to first route the two Harness A and Harness B as per the given harness layout.
Figure 1: Shows the layout of two Harness A and Harness B
The electrical connectors are represented by numbers in the above figure. There are 8 different types of connectors at 10 different locations.
2. Bundle continuity has to be checked for the two created harnesses.
3. After the two Harnesses are created, the next objective is to have them interconnected electrically.
4. Check for bundle warnings in Harness A and Harness B.
5. Add annotations to all the connectors in Harness A and Harness B.
Content:
The following steps are to be done to complete this project.
Intially Bundle Connection Point and Connector Connection Point is Created to all the parts to make them electrical
1
2
3
4
5
6
7
8
9
10
Now Created Two Assembly's as Mentioned In the Layout
Assembly B
Assembly A
And, Now the Both the Assembly's are joined electrically
Annotatins are already mentioned in the above pictures with number
And, as you see there is no bundle warning
Bundle Connectivity Check
Assembly has been changed in to CATpart and thern in to igs format