Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

AIM- Route two electrical harnesses as per the given layout and interconnect them as a single harness assembly and then check for bundle continuity, bundle warnings, and then give annotations to the final harness assembly.

OBJECTIVE-

The objective of this project is to first route the two Harness A and Harness B as per the given harness layout.

Shows the layout of two Harness A and Harness B

The electrical connectors are represented by numbers in the above figure. There are 8 different types of connectors at 10 different locations.

2. Bundle continuity has to be checked for the two created harnesses.

3. After the two Harnesses are created, the next objective is to have them interconnected electrically.

4. Check for bundle warnings in Harness A and Harness B.

5. Add annotations to all the connectors in Harness A and Harness B.

Content:

Define all the electrical connectors geometrically and electrically so that they can be used in the wiring harness.

RESULT:

Hence,Sucessfully Routed the given harness layout in Electrical workbench as per given Condtions.