Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

Wiring Harness Design Challange

Aim:

Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use the connectors provided. After completion of routing,

1. Check the bundle Continuity. Add snap of result in submission
2. Add annotation to all connectors. Make an assumptions for annotations like connect 1 , 2 etc
3. Check for the bundle warning. Add snap.
4. Generate CAT.part of harness assembly and convert is in. igs format.

• All the connectors shouhld be Download after Extract to stp files after open into Catia all the connectors should be Electial defined .
• Bunndle Warnings to be check .
• Bunndle Connectivty Check .
• Connects Harness A& B
• Genarate CATpats into igs file.

Electical definend Connectors.

Harness A:

After all the connectors are defined, the workbench was switched to Electrical Harness Assembly where Geometrical Bundle was activated. All the connectors were routed using the Multi-Branchable Document command.

Harness B:

After all the connectors are defined, the workbench was switched to Electrical Harness Assembly where Geometrical Bundle was activated. All the connectors were routed using the Multi-Branchable Document command.

Bunndle Connectivity:

Annotations:

Genarate Cat Part into Igs file;