Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

                          Modeling Week 5 & 6 Challenge

Aim:

1. Route two electrical harnesses per the given layout and interconnect them as a single harness assembly
2. check for bundle continuity and warnings, and then provide annotations for the final harness assembly.

Objective:

1. The objective of this project is to first route Harness A and Harness B as per the given harness layout.

Figure 1: Shows the layout of two Harness A and Harness B

HARNESS B CONNECTOR PARTS

1)

2)

3)

4)

5)

HARNESS B ASSEMBLY

HARNESS A CONNECTOR PARTS

6)

7)

8)

9)

10)

HARNESS A ASSEMBLY

HARNESS ASSEMBLY

CONNECTIVITY CHECK