Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge
WIRING HARNESS ROUTING:
A WIRING HARNESS IS AN ORGANIZED SET OF WIRES,TERMINALS AND CONNECTORS THAT RUN THROUGHT THE ENTIRE VEHICLE AND TRANSMIT INFORMATION AND ELECTRIC POWER.THE WIRING HARNESS DESIGN IS THE PROCESS BY WHICH AN ENGINEER EVALUATES THE REQUIREMENTS OF AN ELECTRICAL PART OF SYSTEM
- FIRST WE WANT TO DOWNLOAD ALL THE CONNECTOR PARTS AND WE WANT TO DEFINE ALL THE PARTS REQUIRED AS AN ELECTRICALLY
- AFTER DEFINING ALL THE PARTS ELECTRICAL THEN ONLY CAN DO ROUTING TO THE CONNNECTORS AND MAKE THE NEW CATLOGUE TO SAVE THE ALL THE PARTS IN SINGLE FILEE
- THEN USE THE GEOMENTRICAL BUNDDLE OPTION TO DEFINE THE ASSEMBLY PARTS AS CONNECTOR.THEN USE THE MULTI BRANCHING OPTION TO START ROTING TO THE ALL THE PARTS
- AFTER THE ROUTING OF THE PARTS GO TO ADD BRANCH POINT OPTION TO ADD THE BRANCH TO THE ROUTING AREAR . IF ITS IS NESSESARY TO USE THE BRANCH POINT OPTION
- THE COP[Y THE TWO FILE AND MAKE THE SINGLE ASSEMBLY FILE AND USE THE ROTING OPTION TO ROUT THE SURFACE AND SAVE IT BY USING SAVE MANAGEMENT OPTION TO SAVE ALL T5HE PARTS
- THEN USE THE CATOLUGE OPTION AND SAVE THE PARTS OF CONNECTOR IN AFTER THE LATER USES
