Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge
AIM ;
- Route two electrical harnesses per the given layout and interconnect them as a single harness assembly
- check for bundle continuity, and bundle warnings, and then provide annotations for the final harness assembly.
OBJECTIVE :
- The objective of this project is to first route the two Harness A and Harness B as per the given harness layout.
HARNESS A
After all the connectors are defined, the workbench was switched to Electrical Harness Assembly where Geometrical Bundle was activated. All the connectors were routed using the Multi-Branchable Document command.
HARNESS B
After all the connectors are defined, the workbench was switched to Electrical Harness Assembly where Geometrical Bundle was activated. All the connectors were routed using the Multi-Branchable Document command.
HARNESS ASSEMBLY
CONNECTIVITY CHECK
ANNOTATIONS
Converted as a part body and save as IGS Format
