Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

Objective : To route the harness as per given in below drawing - Harness A and Harness B. The Electrical Connectors are represented by numbers in the figure. There are 8 Different types of connector at 10 dufferent location. The Electrical Connectors are represented by numbers in the figure. There are 8 Different types of connector at 10 dufferent location. Bundle contunuity has to checked After the two harness are created the next objective is to have them interconnected electrically Check for bundle warnings in harness A and B. The final objective of this project is to convert the final harness file into IGS file format.

1. Check the bundle Continuity. Add snap of result in submission
2. Add annotation to all connectors. Make an assumptions for annotations like connect 1 , 2 etc
3. Check for the bundle warning. Add snap.
4. Generate CAT.part of harness assembly and convert is in. igs format.

1) Define all the electrical connectors geometrically so that they can be used in wiring harness.

Create Harness Assembly A and B as per the Below Image.

Harness B

Harness A

Final Assembly

Annotations added

.Catpart is generated from assembly.

Iges files has been created from save as option.

Check the bundle Continuity.