Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

To begin with I have downloaded the 4 connectors from TE.com.

1) DTO6-2S

2)DTO6-4S

3)DTO6-6S

4)DTO6-8SA

After downloading all the connectors from the te.com I have defined electrically and later I have created the catalogue family called connectors and I stored the connectors in the catalogue.

I used Electrical Harness Assembly workbench for routing.

I created multiple product files to open differnt connectors and later I assembled all the connectors at one place and I defined geometrically.

With use of multibranch I routed the connectors.

In branch definition we can see the command called route definitin it is main part of the routing.

I arranged the connectors in such a way that DT06-8SA is connected at the left part and DT06-6S at the right side. I created 2 DTO6-2S and 4S, at the top side 2S connectors at the bottom side we have 4S connectors.

Add branch point command used to connect the routing between bundles.

I set the bundle diameter of 10mm and bend radius of 15mm.

At last with the help of protective covering command insulation tubes are covered by corrugated tubes with the dia of 15mm.