Wiring harness design in CATIA V5 - 3D modeling Week 2 Challlenge

Aim: Route the Wiring Harness on given Car body and prepare flatten view drawing in Catia V5 Objective: The objective of this project is to route the wiring harness and prepare flatten view drawing for the tailgate of the car. All types of packaging rules have to be considered while routing the harness and industry based…

Aim- To route the wiring harness on given Engine and flatten view drawing in CATIA V5. Objective- The objective of the project is to route the wiring harness on given Bugatti V16 Engine and prepare flatten view drawing in CATIA V5. All types of packaging rules have to be considered while routing the harness. Also, Industry…

Let, we have to flatten the Harness Assembly completed in Week 4 Challenge. So our objective is, To flatten the Harness Assembly. To place the flattened view on drawing sheet. To ensure bundles with protective coverings has different visuals on drawing view.   Above image shows the Harness Assembly completed in Week…

Let, we have provided the harness layout as below and accordingly we have to route it. For that we have to make assumption for harness bundle diameters and use DT connectors. Step 1: We have to first define all the connectors geometrically and electrically as shown in below images. Step 2: Now, we have to create Harness…

Let's route the following electrical harness layout step by step for that we have to use connectors shown in following layout- DT06-2S DT06-4S DT06-6S DT06-08SA    Step 1:  We have to give geometrical properties to all connectors and define them electrically in electrical part design workbench in CATIA V5. DT06-2S DT06-4S…

Q1. Download following clip cad data & define it as Electrical support using Electrical Part design Workbench. Define all the necessary properties. Hellarmann Tyton – 21160129 Answer: According to provided cad data, P-Clamp (Hellarmann Tyton – 21160129) is designed and defined as electrical support by using…

PROPERTIES OF CONNECTORS AND CLIP After defining the component as Connector in electrical part design, we have to define below properties to the same-- 1. Bundle Connection Point: In above image, bundle connection point is shown. This point is located at center of the bundle segment side or wire entry side. This is the…