Week 9 - Project 1 - Door Trim Lower with Engineering Features

Door Trim Lower with Engineering Features

OBJECTIVE

To Create the Door Trim Lower with Engineering Features Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

INTRODUCTION

ooling Axis: It is direction along which the core and cavity open and close. Draft is also given along the tooling axis.

Class A surface: It provides information about the aesthetic features of a component. The product designer starts development of design models from class A surface

Class B surface: It provides information about the engineering features of a component. This surface is created by offsetting it from class A surface.

Class C surface: It is a surface that connects surface A and surface B along tooling direction.

Part Body; It is a closed surface

Conclusion

Created Door trim with given parameters.

Here used class A surface as referance.

Tree stucture is maintained.

Tooling axis created by using Normal to surface line command .