Week 9 - Project 1 - Door Trim Lower with Engineering Features
* Aim- The main aim is to create the locators and heat stakes on the plastic model.
* Given Class A surface-
- So we have a given class A Surface From that surface we have to design A plastic model.
* Tooling Axis creation-
- We Have to create tooling axis on the given class A surface.
- extract A flat surface on the class A And make a point on that surface, After that create a line perpendicularl to the surface.
- Now check A draft analysis.
* Create A Class B From Given ClassA Surface.
* C surface-
- Now create a C surface To join Class A And Class B And Trimmed it togathe to make a single Surface.
- And We get A Final Plastic product With proper drat Angle.
- Now Make the model As A solid model model using close surface command.
- And Create A locators And Heat Stakes On The solid model With the Proper Fillets nd Draft Angles.
- And Now Take a draft analysis at the end.
* Expanded tree structure.
CONCLUSION: Finally the DOOR HANDLE component has been created through the given Class-A surface, with the dog house. locators following the design rules, with the tooling axis for the given Class-A Surface, created meeting the requirements of the draft angle and at the end performing the Draft analysis on the model.