Week 9 - Project 1 - Door Applique Design with Engineering Features

AIM: Create the door applique plastic component, create tooling axis, Heat stakes & locators by using class-A surface.

SOLUTION:

Create tooling axis

Make a close body by using Class A surface

Create a drawing for a 4-way locator:

Then pad the 4-way locator sketch:

Give the draft to the way locator & give the fillet & chamfer to it,

After that translate the same 4-way locator to another side also,

Now make a 2-way locator draw a sketch & pad it:

Give the draft, Chamfer & edge fillet to a 2-way locator:

Trim the Locators with door applique:

Our next step is to extract the Lower & upper edge & Transfer this corve 10 mm on the surface & make a equidistant point on it

After that, we can start work on the Heat stack.

For that draw a sketch:

Then Pad it

and translate the heat stack to all over Point:

After that trim the Heat stakes with a Door applique

Now make a circle On a locator For creating hole on our door panel:

Pad it & then remove it from the Main body

Give the draft to it:

Remove this body with Door panel

Make that hole for the other two locators also

That is our final product

Draft analysis:

Tree structure: