Week 9 - Challenge 1 - Base Bracket Design

Base Bracket Design :-

Aim: To create a Base Bracket Plastic Component through a given Class A Surface and perform Draft Analysis on the final plastic component.

• Introduction: In this project we are designing a base bracket using given class A surface. The approach includes creation of Class B surface keeping 3 mm thickness in mind for the complete component. The design also included Class C creation from the given parent surface.

CLASS A:

Draft Analysis for Surface A:

• The analysis is done for 3degree draft. So as can be seen all the surfaces are more than 3deg.

Creating of Tooling Axis:

Create a bisecting line using the lines shown above.

Creation of Class B: