Week 8 - Challenge 6 - Core & Cavity Design

TOOLING AXIS:

TOOLING AXIS IS CREATED AT A SURFACE PERPENDICULAR WHERE WE CAN VISUALIZE MORE ELEMENTS IN THE VIEW.CREATE A POINT ON THE SURFACE WITH MULTIPLE EXTRACT AND MAKE AN AXIS THEN CREATE A SKETCH 1 WITH AXIS SYSTEM AND PROJECTION POINT THEN KEEP IT IN N0 3D BACKGROUND .MAKE TWO LINES TO CREATE A BISECTING LINE ON IT .THEN CREATE ANOTHER SKETCH WITH YZ AXIS SYSTEM WITH PROJECTION POINT CREATE AN INTERSECT AND CREATE A LINE WITH MINIMUM 3 DEGREE THEN BISECTING LINE AXIS APPEAR.THEN BY SKTECH1 AND SKETCH 2 AXIS WE CAN CREATE A BISECTING LINE.

DRAFT ANALYSIS:

IT IS USE TO ANALYSE PROPER DRAFT ANGLE FOR A COMPONENT AND DESCRIBIES THE AMOUNT OF TAPER REQUIRED TO REMOVE THE COMPONENT PART FROM THE PARTITION LINE.

DRAFT ANALYSIS ON SWITCH BEZEL COMPONENT:

CORE AND CAVITY:

CORE AND CAVITY ISOMETRIC VIEW:

FRONT VIEW:

SIDE VIEW:

TOP VIEW: