Week 8 - Challenge 6 - Core & Cavity Design

YOU CREATE A GEO-SET TO AND COPY CLASS A , B & C SURFACE

NOW WE TRIM IT, AND GET RESULT FOR POISITIVE DRAFT AGNLE ONLY, NOT THE RED AREA. AS WE DID IN ANALYSIS.

NOW, EXTRUDE, RECTANGULAR FACE FROM THE SKETCH, AND TRIM IT WITH SURFACE, AND AGAIN THEN FILL IT AND MAKE IT CLOSED SURFACE.

NOW WE USE SAME SKETCH TO EXTRUDE TO OTHER SIDE FOR CAVITY SIDE, AND WE TRIM IT. AND HENCE MAKE THE CLOSED SURFACE AS BEFORE.

NOW USING CLASS B SURFACE AND CLASS C SUIRFACE WE DO CREATE AN INSTERSECTION LINE , THAT IS CALLED, PARTING LINE.

NOW USING, PARTING LINE, WE TRIM THE CLASS B SURFACE HENCE WE GET PARTING SURFACE.

HENCE WE CAN SIMULATE USING TRANSLARTION TOOL TO MOVE,

THANK YOU.