Week 8 - Challenge 5 - Door Trim Lower

REPORT

• The tooling axis is created by the bisecting line method.The intersection of xy with surface A and intersection of yz plane with surface A are here used for the tooling axis creation.The steps involved in the tooling axis creation are detailed in the tree structure.
• Done the draft analysis of surface A with tooling axis and find out that surface A is clearing.
• Also done the draft analysis of final part with tooling axis and find out that there is some color changes in the draft analysis.some regions found in red color which means that the angle here is less than the 3 degree.The draft analysis of final part is attached in the challenge submission box
• All the surfaces and tooling axis are published for the future reference.

DRAFT ANALYSIS-SURFACE A

DRAFT ANALYSIS- FINAL PART