Week 8 - Challenge 4 - Bumper

Aim: To route the wiring harness on the given backdoor assembly and prepare the flatten view drawing in CATIA V5.   Objective: The objective of this project is to route the wiring harness and prepare flatten view drawing for the Backdoor of the car. All types of packaging rules have to be considered while routing the harness…

 AIM  Route the Wiring harness on Given Engine and Prepare flatten view drawing in CATIA V5. Application of all Packaging rules, Industry best practices studied in this course shall be demonstrated in design. Apply Protection coverings as required. Engine wiring harness routing  The above figure shows the…

AIM: TO FLATTEN THE WIRING HARNESS AND DRAFT THE WIRING HARNESS ASSEMBLY. GIVEN: HARNESS ASSEMBLY: HARNESS FLATTENING: WE GO TO THE HARNESS FLATTENING WORKBENCH AND DEFINE THE FLATTENING PARAMETERS. WE USE THE EXTRACT COMMAND TO BRING THE HARNESS ASSEMBLY TO THE FLATTENING WORKBENCH HERE. CHOOSING A SUITABLE PLANE WE FLATTEN…

Aim: Route two electrical harnesses per the given layout and interconnect them as a single harness assembly check for bundle continuity, and bundle warnings, and then provide annotations for the final harness assembly. Objective: The objective of this project is to first route the two Harness A and Harness B as per the…

Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram. Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)   Hareness layout…

Q1. Download following cad data & define it as Electrical support using Electrical Part design Workbench. Define all the necessary properties.       Procedure Create two points one as entry and another as exit point. create planes at two points and another at base. Switch to Electric part desgn Click…

AIM: Download following connectors & Connector clip cad data from given link & define it as Electrical Connector using Electrical Part design Workbench. Define all the necessary properties to Connectors & Clip.   Deutsch DT06 – 08SA ( https://www.te.com/usa-en/product-DT06-08SA.html) Tyco 174357-2…

AIM Create the A Pillar Plastic component through the given Class-A surface and master section and perform Draft analysis.   THEORY CLASS A SURFACE: Class A surface is a surface made by the designer specially in automotive design which is the aesthetic part of a body and is given as an input to the plastic designer…

Aim:-- Create the door trim lower plastic component through the given class-a surface. To begin with, the tooling axis for the given class-a surface should be created meeting the requirements of the draft angle and at the end perform the draft analysis on the model.  Create the heat stakes and the locators considering…

Attachment Feature Creation - Challenge 2   AIM Create the Dog House for the Door Trim considering the design rules   INTRODUCTION DOG HOUSE Dog house is an engineering feature used in plastic design. Dog houses are used as support feature. Sometimes other engineering features like snaps, locators, screw bosses…

DOOR HANDLE: - AIM: To Create the Door Handle Component from the given Class-A surface. To Create the tooling axis for the given Class-A Surface meeting the requirements of the draft angle. To Attach B Side Features in the component. To perform the Draft analysis on the model.    PROCEDURE: -   FEATURE TREE:…

  Aim: To create the class B surface, C surface and tooling axis also publish it as well as close surface the given door trims. Objectives: Create the Door Trim Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements…

                                                                                           …

                                    Report A detailed report should be done explaining the draft analysis and the tooling axis creation.  Select the draft analysis then select the quick analysis mode then select the compass to…