Week 8 - Challenge 4 - Bumper

DRAFT ANALYSIS; THE DRAFT ANALYSIS COMMAND ENABLES YOU TO DETECT IT THE PART YOU DRAFTED WILL BE EASILY REMOVED. THIS TYPE OF ANALYSIS IS PERFORMED BASED ON COLOR RANGES IDENTIFYING ZONES ON THE ANALYZED ELEMENT WHERE THE DEVIATION FROM THE DRAFT DIRECTION AT ANY POINT CORRESPONDS TO SPECIFIED VALUES. EXTRACT; THE EXTRACT DEFINITION DIALOG BOX IS DISPLAYED SELECT EDGE OR THE FACE OF AN ELEMENT. THE SELECTED ELEMENT IS HIGHLIGHTED. TRIM; IF GO FOR OTHE SIDE NEXT ELEMENT I WILL I CAN SWITCH THIS SIDE HERE OKAY AND OF COURSE ITS AUTOMATIC EXTRAPOLATED. SO THOSE SURFACES NEED NOT BE THE SAME SIZE. OFFSET; THE OFFSET SURFACE TOOL CREATES A NEW SURFACE BODY FROM AN EXISTING SET OF FACES. THE FACES MAY BE SOLID OR SURFACES. TO CREATE AN OFFSET SURFACE. CLOSE SURFACE; THIS TASK SHOWS YOU HOW TO CREATE A SOLID BY CLOSING THE JOINED SURFACE. FOR THIS YOU MUST CALL UP THE CLOSE SURFACE DEFINITION DIALOG BOX. EXTRAPOLATED; EXTRAPOLATION IS AN OPERATION IN WHICH AN ELEMENT IS EXTENDED A SPECIFIED AMOUNT WHILE RESPECTING TANGENCY OR CURVATURE CONDITIONS. TYPICALLY A SURFACE BOUNDARY CAN BE SELECTED FOR IN ORDER TO EXTRAPOLATE THE SURFACE A SPECIFIED LENGTH, BOUNDARY; THE SELECTED EDGE IS PROPAGATED AROUND THE ENTIRE SURFACE BOUNDARY. POINT CONTINUITY THE SELECTED EDGE IS PROPAGATED AROUND THE SURFACE BOUNDARY UNTIL A POINT DISCONTINUITY IS MET. TANGENT CONTINUNITY THE SELECTED EDGE IS PROPOGATED AROUND THE SURFACE BOUNDARY UNTIL A TANGENT DISCONTINUNITY IS MET. SWEEP; A SWEPT IS CREATED BY WEEPING OUT A PROFILE IN PLANES NORMAL TO A SPINE CURVE WHILE TAKING OTHER USER DEFINED PARAMETERS INTO ACCOUNT. EDGE FILLETS; A FILLET IS A CURVED FACE OF A CONSTANT OR VARIABLE RADIUS THAT IS TANGENT TO AND THAT JOINS TWO SURFACES. TOGETHER THESE THREE SURFACES FORM EITHER AN INSIDE CORNER OR AN OUTSIDE CORNER. INTERSECTION; THE INTERSECTION DIALOG BOX APPEARS AS WELL AS THE TOOLS PALETTE. FOR FURTHER INFORMATION ABOUT THE TOOLS PALATTE, REFER SELECTING USING SELECTION TRAPS IN THE CATIA INFRASTRUCTURE USERS GUUIDE. SELECT THE TWO ELEMENTS TO BE ITERSECTED. THE INTERSECTION IS DISPLAYED. MULTISECTION; MULTI SECTION SURFACE DEFINED BY THREE PLANER SECTION. SECTIONS CAN BE 3D CURVES DROVIDINA THAT THE INTERSECTION BETWEEN ONE 3D CURVES PROVIDING THAT THE INTERSECTION BETWEEN ONE 3D PROFILE AND ALL GUIDES IS COPLANR. MIRROR; MIRRORING A FEATURE. IN THIS TASK YOU ARE GOING TO MIRROR A GIVEN FEATURE THAT IS TO DUPLICATE IT SYMMETRICALLY WITH RESPECT TO A PLANE. YOU CAN MIRROR A HOLE A WALL, A WALL ON EDGE , A CUTOUT, AFLANGE, A STAMP, A PATTERN OR ANOTHER MIRROR.