Week 8 - Challenge 3 - Switch Bezel Design

REPORT ON TOOLING AXIS :

AS THE GIVEN COMPONENT HAS CONCAVE SHAPE IN THE Z_DIRECTION , ITS DIFFICULT TO CREATE MOULD OPENING IN THE X AND Y DIRECTIONS. IF THE MOULD IS OPENED IN THE Z-DIRECTION ALL THE COMPONENT IS COVERED. THAT IS TOOLING DIRECTION SHOULD BE IN THE Z DIRECTION

I CREATED TWO LINES ON THE CONCAVE FACES WHICH ARE IN THE Y DIRECTION , AND CREATED A BISECTING LINE OF THE LINES THROUGH THE CENTER POINT, IN THE X-DIRECTION , I CREATED A LINE ON THE FACE OF THE CONCAVE SHAPE AND ON THE OTHER SIDE , AS THERE IS NO FACE , CREATED A LINE WITH THE DRAFT OF 3 DEGREE, THERE BY CREATED A BISECTING LINE OF X AND Y DIRECTION CENTER LINES THROUGH THE POINT WHICH WOULD BE THE TOOLING AXIS OR MOULD OPENING DIRECTION.

REPORT ON DRAFT ANALYSIS:

FOR CLASS A SURFACE :

AS THE COMPONENT HAS AN APPROPRIATE ANGLES I HAVE GIVEN 5 DEGREE , IT IS SHOWING GREEN COLOUR POSITIVE DRAFT THAT IS MORE THAN 5 DEGREE ,RED COLOUR FOR THE DRAFT THAT IS BETWEEN 0 TO 5 DEGREE AND BLUE COLOUR FOR NEGATIVE DRAFT.

FOR THE THICKEN COMPONENT

IN THE DRAFT ANALYSIS THE GREEN COLOUR INDICATES THE DRAFT OF MORE THAN 5 DEGREE , RED COLOUR INDICATES THE DRAFT OF RANGE BETWEEN 0 TO 5 DEGREE AND BLUE COLOUR INDICATES THAT THE DRAFT THAT IS NEGATIVE.

FOR CLASS A SURFACE :

AS THE COMPONENT HAS AN APPROPRIATE ANGLES I HAVE GIVEN 5 DEGREE , IT IS SHOWING GREEN COLOUR POSITIVE DRAFT THAT IS MORE THAN 5 DEGREE ,RED COLOUR FOR THE DRAFT THAT IS BETWEEN 0 TO 5 DEGREE AND BLUE COLOUR FOR NEGATIVE DRAFT.

FOR THE THICKEN COMPONENT

IN THE DRAFT ANALYSIS THE GREEN COLOUR INDICATES THE DRAFT OF MORE THAN 5 DEGREE , RED COLOUR INDICATES THE DRAFT OF RANGE BETWEEN 0 TO 5 DEGREE AND BLUE COLOUR INDICATES THAT THE DRAFT THAT IS NEGATIVE.