Week 8 - Challenge 3 - Coin Holder Design

Kindly consider the below attached files for the above challenge.

Tooling axis creation -

• Base of the given A surface is extracted.
• A point is marked on the extracted flat surface.
• Since the walls of the given A surface is almost perpendicular the the surafce so, A line is generated normal to the flat surafce at the marked point.
• The generated line is taken as tooling-axis for the given A-surface.

Draft analsys is done on the given A-surface and analysed green pattern overall.

Draft analsys is done on the final close surafce and same green pattern is analysed overall.