Week 8 - Challenge 2 - Switch Bezel Design

Kindly find the attachments below for the above challenge.

The steps followed for the tooling axis are as follows.

• first base part is extracted from the class A surface on which as point is marked.
• On the marked point the suface intersect is defined in x axis.
• Through the intersect two lines are created and the bisected to get a single line.
• same process is repeated in Y direction and Y axis is created.
• Now x and y axis is bisected to get single a tooling axis line.

Draft analsys is done on Class A surface show green colour which gives draft of 3 degrees and above, below 3 is red and o -3 is blue.

Draft analsys done on final part show green upto 2 degrees and blue for less than 2 degrees.

Thankyou