Week 8 - Challenge 2 - Switch Bezel Design

AXIS CREATION.

BISECTING LINE

TOOLING AXIS

DRAFT ANALYSIS CLASS A REPORT

DRAFT NOT CLEARED AT 3 DEGREE.

GIVEN CLASS A DIDNT CLEAR DRAFT ANALYSIS AT 2.9, 2.8, 2.7, 2.6 FURTHER TRIED TILL 2.3

DRAFT ANALYSIS CLEARED AT 2.2 DEGREE.

CLASS B.

CLASS C.

CLASS A,C JOINING.

FINAL CLASS A,B,C.

SOLID BODY.

DRAFT ANALYSIS OF FINAL PROJECT.

ITRATIONS TIED ON 3 DEGREE LINE TOOLING AXSIS

FROM 3 DEGREE TO 1 DEGREE BUT DRAFT ANALYSIS NOT CLEARED

IT SHOWS DRAFT CLEARED FORM BOTTOM SIDE.

FURTHER TRIED ON BISECTING TOOLING AXSIS.

2.2 DEGREE.

1.9 DEGREE

1.4 DEGREE

THIS DRAFT ANALYSIS IS DONE ON 4 DEGREE TOOLING AXIS BY CHANGING ANGLE FROM 3 TO 4 DEGREE.

AT 2.9DEGREE

CLASS A DRAFT ANALYSIS ON NEW TOOLING AXSIS OF 4 DEGREE.