Week 8 - Challenge 1 - Base Bracket Design

Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. 

Screenshots of the Draft analysis report for both the given Class-A surface and the final plastic component

CLASS A SURFACE

B SURFACE

C SURFACE

DRAFT ANALYSIS

CREATING POINT-TO-POINT ON BOTH SIDES

CREATING A BISECTING LINE

FORM A TOOLING AXIS AND PERFORM A DRAFT ANALYSIS

After completion of the draft analysis, extract surface one by one from the class A surface and untrim it then do extrapolate the surface and trim it to get a required shape

After completion, the above-mentioned operation gives a required fillet value on sharp edges(3mm+2.5mm) to get a complete B surface as below

Then select the boundary of the class A surface and sweep it for 3 deg to get a surface as below

Finally Unhide the class B surface. Trim the unwanted portion to get a final completed surface. (i.e combination of Class A, B, and C) as below

TREE STRUCTURE WITH ALL PUBLICATIONS

Screenshots of the solid model with the proper color code of the draft angle in various orientations (Isometric, Front, Side, and Top View)

FRONT VIEW

SIDE VIEW

TOP VIEW

ISOMETRIC VIEW

FINAL CLOSE PART BODY

                                                   *****THANK TOU*****