Week 7 Challenge - Assembly Workbench

AIM: 1. To create the individual part files and then create a complete assembly of those part files in the assembly workbench.

2. After creating the assembly create a 2D drawing similar to the one given in the assignment folder using drafting tools.

PROCEDURE:

1. Using the given 2D Drawing create the individual parts.
2. After creating the parts create the assembly and import or copy the individual parts.
3. After copying and importing the parts, create the necessary Reference Points and Axis by importing the Geometrical Set into individual part files.
4. Use the option Publications and publish the References in the individual part files.
5. Now create the new part file and create the reference point and this is the reference point to the entire assembly.
6. Using the appropriate the constraints finish the assembly and it should be constrained as the real life scenario.
7. Than using save management option save the assembly and parts in the same folder.
8. Now using the drafting tools create the 2D Drawing.

Note: We can create the 2D Drawing after creating the individual parts by leaving the gap of 1st sheet and that sheet is used to draft the complete assembly at the end to save the time.