Week 7 Challenge

Dear Sir,

Here I have attahced the week 7 challange fo ryour reference. Here I have created two sliders and guide rail and stopper

Here I have mentioned the steps followed to create to the slider and guide rail

1) First we need the chek the slider profile (wheather it is in core side are cavity side) In your file it is in cavity side so now we are going to work in cavity side

2) Now we need to open the cavity part file (we have to work on that for creating the slider area)

3) Need to make transperant in all the slide of the cavity block to see the slider profile clearly(right click in the surface and click transparent)

4) Now we need to create the plane by using the slider surface and sketch on it

5) Make the entire slider profile using the convert entries and exit the sketch

6) now use the split commant (Direct editing -split) Now select he sketch and select the plane now you select the slider profile alone and click ok

7) now u can see the two bodies in the solid bodies option (one is slider and another one is cavity off)

8) You cana see the hole in that slider profile for creating that sketch again in that same plane nad create the same profile slot by using convert entries

9) now extrude that profile (Upto next surface)

10)Now we have to make the perfect slider profile by using cut extrude nad boss exturde command ( as shown in the video)

11) now make a copy of the slider profile (because we add some extra profile in that silder so we need to cut that same profile in cavity surface)

12) For cutting that profile we are going to use subcrate ioption (Direct editing - combine)

13)Select the subract option and select the main body and select the copied slider

14) Now we get the entire slider profile in that cavity surface

15) now we need to fill surface (the extra cut made) while spliting the slider surface

16) use extrude boss option for adding material

17) need to do fillets in all hte sharp edges of the slider (same fillets have to make in cavity side also)

17) now used the same steps for creating that opposite side slider

18) now both the silders created . now save the slider in to seperate part file

19) now get into a main assy

20) create the new part file (slider)

21) And insert the slider in that position (Insert-features-import)

22)now we need to create the guide rail for slider area

22) Right click in core off and select the edit part

23) now make the guide raile profile and exturde it

24) Now we have to make a under cut in the cavity profile.(Guide rail profile)

25) Now we have make a screw to lock the guid rail

26) Create the new part and sketch on it now create the screw profile as shown in the video

27) now we have to make a thread hole in the core block. to mount the screw

28) Hole hazard option have to use to create the hole in the core bolck

29) now we have to create the stopper for the slider for that we have create the locking profile shown in the video and make cut extrude

30) now we to cut a semi circle profile in the slider edge surface (the think to note here is whle moould opening time the entire slider have to come out from the part area then only the part will release properly) for that we have to ensure the slider stopper position