Project 2

Dear Sir,

Here I have attached the Project 2 for your kind reference

Mentioned the steps for creating the mould

1. we need to check the draft analysis ( the sufficient draft given in the mould are not)
2. scale (we need to add the shinkage for the part to get accrute dimension after the part gets solidified)
3. parting line
4. shutoff surface (Now the core and cavity surface created)
5. we have to create the parting surface
6. we need to kinit the parting surface to the core and cavity surface
7. Now we need too move on to the Assembly
8. We need to insert the part file
9. We need to make the centre position (sprue position is the centre position)
10. Now we have to create the core and the cavity block
11. then we have to create the sliders for the mould
12. we have to move on the cavity injection unit(for this modle we need only the sprue. there is no sub runners)
13. In core part file we have create the ejction assy (need to create the ejection pins where ever it required)
14. And then bottom plate
15. finaly we need to provide the air vent for the model