Week 6 Challenge

1. Aim:-To Create a rectangle using micostation with Feature defination matchline.

Procedure:We have to create a rectangle.So In drawing section of ORD in placement bar we used Place Line tools to draw rectangle first.Now using Complex geometry tool bar click on Complex by Element tool and add one by one side of rectangle to make complex of simple element.Noe we can set the fetaure defination for the rectangle as Linear >machline from tool itself or set feature defination from toolbar to be done As complex rectangle.

Please see the attachment:-

Result:-Hence we can say that using mirostation we can set as complex using Complex by element tool bar from geometry and set fetaure defination as required.

2. Aim:-To Create Geometry using geometry builder tool

Procedure:It is an another type to create gometry.It can be used to build geometry as per need at required place.First we open new geometry ,click begin point and place that point on ORD.Then we start to add line ,arc or spiral to build geometry.we can also delete any line or arc from right side of toolbar.Then place save to as geom bl XML file to change in further drawing as well.There is no civil rule applied on this geometry because of microstation line build through this.

Please see the attachment:-

Result:-Hence we can draw geometry at begin point as line or arc as per requirement.

3. Aim:-To Design the Roadway layout with driveway at intersection refering Aerial background imgery.

Procedure:-First open a 2D dgn file and attached reference as made earlier i.e. Main line alignment.Now take offset from center a 12' lane and 10' shoulder as well.Now we can Extend and taper the proposed alignment to the Existing and topo limit for the same and complete the proposed alignment refered through background imagery.

Please see the attachment:-

Result:-Hence we can draw the proposed alignment as per topo limit and background imagery,taken reference to the existing cener line of road.

4. Aim:- To design an alignment that shown on profile view too with station 50+00.

Procedure:First all we have to draw an alignment using aerial imagery.Now make the alignment as complex.Click on profile view to show the vertical profile on another view i.e view 8.Now attached a reference file E-terrain to obtained the existing ground level of the alignment.Make the terrain active .Open civil acudraw to make a proposed line upon Existing ground and name PGL_INT_01.Set the proposed line active on that alignment and done with station 50+00.