Week 3 Challenge : CFD meshing on Turbocharger

AIM:

To the CFD meshing of a cylinder solve the ansa software.

METHODALOGY:

First open the new file insert the turbo charger model and to check the component of double layer that is removed.

To go check the option to under geometry to verify the single cons error and triple cons error.

Then properly remove first single cons error and do the topomodel to under the option faces and cut option to solve the all error and triple cons error don’t change the component.

They all solved error go the check option to under the geometry verified.

Then again check the component all side in put any double layer the uses delete option to removed.

The start to surface meshing to put given the values and the mesh under to option length and spot mesh but their option before set the quality criteria and mesh parameters to values.

They all parts of component values enter same process do again the again and then solved surface meshing of turbo charger. Mainly check all meshed then go the volumetric mesh.

Then volumetric mesh to under option the define and check to list option.

The mostly check their option carefully to volumes and thickness.

Then remove the thickness part and the finally all parts to enter remesh to tetra CFD.

RESULT:

MESH

SHELL

QUADS: 0

TRIAS: 915770

TOTAL: 915770

VOLUME

TETRA:10117644

TOTAL: 10117644

CONCLUSION:

I conclude the CFD meshing on turbo charger in use the ansa software to solved..