Week 5 Challenge : Surface wrap on Automotive Assembly

AIM:

To the Surface Wrap on automotive assembly solve the ansa software.

METHODALOGY:

First open the new file insert the (Engine, Transmission, Gearbox) model and to check the component of double layer that is removed.

To go check the option to under geometry to verify the single cons error and triple cons error.

Then solve the all parts single cons and triple cons error removed. The topo option used to clear one by one remove cons and mostly under option cut, project ,delete, intersect ,extend, paste there are use to clear the cracks and also cons errors.

They all solved error go the check option to under the geometry verified.

Then again check the component all side in put any double layer the uses delete option to removed.

They all parts of component values enter same process do again the again and then solved surface the model.

Then check the all models in outer side hole all of that closed.

There mesh option under the elements option of WRAP to enter the value length 3mm.

Then check PID`s and the compress option to unwanted PID deleted and all set then run the wrap option that is surface wrap on automotive assembly

RESULT:

MESH

SHELL

QUADS: 0

TRIAS: 662846

TOTAL:662846

CONCLUSION:

I conclude the Surface wrap on automotive assembly in use the ansa software to solved.