Week - 2 - Explicit and Implicit Analysis

AIM            To study about implicit and explicit method to solve engineering problems.OBJICTIVES         To demonstrated in the PDF, F(u) = u3+9u2+4u use this equation and solve using both Explicit and Implicit Methods with…

AIM :     To Create the mesh for bumper assembly, mesh size should be 6mm and simulate the given model with seven different casesin radios as per problem statement and compare it using various plots. SOFTWARE USED :     Altair hyper-works student version 2021 PROBLEM STATEMENT : Create the mesh for…

AIM:       To run crash analysis for the given model by applying different materials laws available in Radioss and post-process the results OBJECTIVE:       To carry out simulations for given starter files and compare the results. There are 7 cases (according to given parameters) and they…

AIM: Run the simulation with the default property card (CASE 1) Changing the property card ( CASE 2) Comparing CASE 1 & CASE 2 PROCEDURE     CASE 1 : WITHOUT ASSIGNING THE RECOMMENDED PARAMETER IN THE PROPERTY Import the model in RADIOSS user interface  Import the file as SOLVER DECK  …

 AIM:         To edit the given engine file and perform 3D mesh for given model. GIVEN:   Engine File Snippet   Questions: 1. Check the material properties of the rail component and calculate the speed of sound in steel rail? 2. The length of the rail is about 1000 mm.calculate the…

Your Answers AIM:           To extract the mid surface of given components and mesh the components under given quality criteria and assign thickness. OBJECTIVE:  To extract the mid surface and mesh it with proper mesh flow.  To ensure the mesh should pass the given Quality Criteria.…

AIM:           To extract the mid surface of given component and mesh the component under given quality criteria and assign thickness. OBJECTIVE:  To extract the mid surface and mesh it with proper mesh flow.  To ensure the mesh should pass the given Quality Criteria.  To assign…

AIM:           To extract the mid surface of given plastic component and mesh the component under given quality criteria and assign thickness. OBJECTIVE:  To extract the mid surface and mesh it with proper mesh flow.  To ensure the mesh should pass the given Quality Criteria.  To…

  OBJECTIVE:           To mesh the given component under given criteria and Create connector and Attach the various parts. GIVEN:        Criteria for mesh        Target Element size - 5 Units S.NO   Quality Criteria    …

OBJECTIVE:           To create tetra mesh for given componenet under given criteria. GIVEN CRETERIA:         For Model 1               TetraMesh Generation Method: 2D to 3D Conversion            Elements…

OBJECTIVE:            To mesh the given componenet under given criteria and assign thickness for it. GIVEN:            Target Element Length = 5 Units   S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2 Units 6 Max. Length 8 Units 7 Min angle Quad 45 8 Max angle…

Objective:         To Mesh the Given component with the Size of 5 Units,Create 1D elements on the following component with given cross-section and DOF by using Hyper Works. Softwaer Used:          Hyper Works 2021 Given Component:            …