Challenge

Week 2 Challenge : Surface meshing on a Pressure valve

Start with the topographic clean-up.
Error found by the check manager with geometry.
Uncheck face, Triple cons, Overlap face, single cons, cracks, etc,
Use wireframe mode.
Select the face and go through in new and used algorithm anyone 1. existing 2. surface 3. planner 3. Fitted and 4. cons with loop option.
PID manager active PID mode what where surface see to already in the screen.
The face is created we can switch to PID display mode to check the different PID in a color.
Select any kind of entity one by one with the left mouse button on the multiple entity buy box selections.
Select a property order one by one with the left Mouse by button are multiple property bi box selection.
Now start the mashing and go topo to Mesh.
Gives the perimeter and macros length.
Select the mesh parameters and give target length.
Select the length from the parameters and give the 1mm mesh length
Select Quality criteria minimum length and maximum length.
After that select Tria.

The above procedure was similar for 3mm and 5mm Target lengths.

I attached three different files of three different cases and share the google drive link.

Ship work like this
in your own course.