Week 12 - Project-1

objective: Mesh the given component with a given quality criteria and assign the thickness.

procedure:1.Import the given geometry and then geometry clean up will be done take the manual mid surface for the component by offset the surface of the given component.

2.Take the given quality criteria as per the given and then split the geometry into 4 parts then create the separate component for that split surface .

3.start meshing the split surface geometry and by taking the mid surafce manually and also element offset method.

4.Repeat the same procedure for each of the split geometry and then after meshing the all surface then check for free edges and duplicates of elements .

5. Apply the thickness to the given ribs of the component.

geometry trim surface1

geometry trim surface 2

geometry trim surface 3

geometry trim surface4

geometry trim surface 5

fig shows meshed component with thickness

https://drive.google.com/file/d/1yOczkA4rqM-yyE1TcWNwtA1miFZOCmRv/view?usp=sharing

conclusion

In this project learnt about the meshing of plastic model with the given quality parameters and taking the manual midsurface and apply the thickness to the particular component.