Week 12- Final project

Aim: Development of a Door Trim Panel

Objective :

The main objective is to create the individual components of the door trim with input class A surface.

Class A surface:

Class A surface is a top surface of door trim panel.

Class B surface:

Class B surface acts as a support surface and joining surface for the integrating parts and to mount on the door frame structure in this case.

Class C surface:

Class C surface is a surface is the thickness surface of the trim panel.

Door trim is consist of below mentioned parts:

•Arm rest

•Lower subtract

•Upper Subtract

•Map Pocket

These individual parts were created and then attached to each other as a product.

Arm rest

Arm rest tooling axis and joining clamps were created.

Snap shots are given below:

Main Tooling axis

Side Core Tooling axis

Tree Structure snap shots

Snap Shot of Draft analysis of arm rest

Lower subtract

Snap shot of tooling axis of lower subtract

Side Core axis for dog house of lower subtract

Tree structure for lower subtract

Draft analysis

Draft analysis of dog house

Upper Subtract

Snap shot of tooling axis of upper subtract

Draft analysis of upper subtract

Tree Structure of Upper subtract

Map Pocket

Snap shot of tooling axis

Draft analysis of map pocket

Tree structure of map pocket

Views of parts from different angles

In each parts below listed parts were also created to join together :

•Heat stacks

•Dog House

•Ribs

•Screw Bosses

•Flanges

•Snap Fits