Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by dhawal sharma (17)
Week 11 Challenge
08 Jul 2021 07:40 AM IST
Project 1
AIM: To route the wiring harness for the given engine. Application of all Packaging rules, Industry best practices studied in this course shall be demonstrated in design. Apply Protection coverings as required. DESIGN CRITERIA AND PACKAGING ASSUMPTIONS: Wiring harness routing shall provide ease in manufacturing, accessibility,…
01 Jun 2021 10:39 PM IST
Wiring harness design in CATIA V5 - 3D modeling Week 7 Challenge
AIM: TO FLATTEN THE WIRING HARNESS AND DRAFT THE WIRING HARNESS ASSEMBLY.GIVEN: HARNESS FLATTENING: WE GO TO THE HARNESS FLATTENING WORKBENCH AND DEFINE THE FLATTENING PARAMETERS WE USE THE EXTRACT COMMAND TO BRING THE HARNESS ASSEMBLY IN THE FLATTENING WORKBENCH HERE CHOOSING A…
06 May 2021 12:45 PM IST
Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge
AIM: TO DESIGN THE GIVEN HARNESS ACCORDING TO THE WIRING DIAGRAMS. GIVEN: HARNESS_A: CONNECTIVITY CHECK : HARNESS B: CONVERTED AS A PART BODY AND SAVED AS IGS FORMAT
04 May 2021 11:42 AM IST
Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
The given connectors were downloaded from the www.te.com The following was defined for all the connectors: Connector connection point bundle connection point axis system at the connector connection point define all the connectors as electrical components The connectors were assembled as the given diagram. We use…
18 Apr 2021 06:57 AM IST
Wiring harness routing & packaging Rules Week 3 Challenge
1) The given clip was downloaded and opened as a part file. We have to define two points which will be used as entry and exit points. Then a plane has to be defined at the points. A base plane has to be defined at a distance of 2 to 3 mm from the clip. again we define the exit point at the first definition as the entry…
07 Apr 2021 11:28 AM IST
Wiring harness design in CATIA V5 - 3D modeling Week 2 Challlenge
1) THE CONNECTOR IS FIRST UPLOADED IN THE PART DESIGN WORKBENCH WE DEFINE THE POINTS FOR CONNECTOR CONNECTION AND BUNDLE CONNECTION. THE AXIS SYSTEMS ARE PLACED ON THE CONNECTOR CONNECTION AND CAVITY CONNECTION POINTS THE ORIENTATION OF THE AXIS SYSTEM IS NOT SPECIFIC, WE JUST NEED…
05 Apr 2021 03:09 AM IST
Design of the Switch Bezel ( A-surface to B-surface Conversion)
OBJECTIVE: To design the switch bezel from the given styling surface. Create the A-surface and tooling direction for the A-surface. Perform draft analysis on the A-surface. Create the B-surface and C-surface. Create the Core and Cavity for the Switch Bezel. SOFTWARE USED: CATIA V5 DESIGN METHODOLOGY Given: A-surface…
30 Sep 2020 02:19 PM IST
Design of Car Hood Inner Panel using the Euro-NCAP regulations /Outer Panel/ Draft Analysis/ Latch and striker position study
DESIGN OF HOOD PANEL FROM THE GIVEN STYLING SURFACE USING CATIA V5 (EURO-NCAP REGULATIONS) Introduction: A car hood panel is one of the most important components of the BIW (body in white), it is considered as the closure sheet-metal component. A hood panel consists of two panels that are hemmed together…
14 Aug 2020 01:58 PM IST