Week 11:- 2D Detailing Challenge 2

AIM:

To Create 2D Drawing for each Clamp Units with all child parts and also create Child pard drawing for the same for the Fixture assembly and to Create 2D Drawing for each Pin Units drawings with all child parts and also create Child pard drawing for the same for the Fixture assembly created in challenge 8.

INTRODUCTION:

The fixture design after the 3D finishing process has to be done with 2D finishing before it is sent for manufacturing. All the dimensions of the fixture units and their child parts have to clearly mentioned in the drawing sheets. The detailing can be changed as per the requirement of the customer and company standards. GD&T must be used in order to reduce the cost of manufacturing.

All the views must be clearly visible and provided with dimensions in the drawing sheets.

CLAMP UNIT:

CLAMP MYLAR:

RISER:

SHRIMS:

L BLOCK:

ROUGH LOCATOR:

REST MYLAR:

SWIVEL CYLINDER:

L BLOCK:

CLAMP MYLAR:

ROUGH LOCATOR:

SHRIMS:

REST MYLAR:

RISER:

CONCLUSION:

Thus 2D drafting of clamp unit and pin unit with all their child parts has been done using catia v5.