Week 11:- 2D Detailing Challenge 2

AIM:

To create 2D drawing for each clamp units with all child parts and also create child part drawing for the same for the fixture assembly created in challenge 8.

To create 2D drawing for each pin units drawing with all child parts and also create child part drawing for the same for the fixture assembly created in challenge 8.

DETAILING PROCEDURE:

Here we are detailing for each and every part of unit.

The first sheet always shows isometric views of the unit or it will be based on the customer requirement but mostly every part drawing done in a single sheet.

Clamp mylar and Rest mylar are always goes to heat treatment process to hardening the mylars. Because this is the only part touches the panel as well Pin also.

Layout drawing is the most important drawing. because all the procurements and assemblies are working based on the layout drawing.

SWIVEL CLAMP UNIT - P001_Z10_ST10_01_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_02_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_03_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_04_00:

POWER CLAMP UNIT - P001_Z10_ST10_05_00:

POWER CLAMP UNIT - P001_Z10_ST10_06_00:

POWER CLAMP UNIT - P001_Z10_ST10_07_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_08_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_09_00:

RETRACTABLE PIN UNIT - P001_Z10_ST10_10_00:

RETRACTABLE PIN UNIT - P001_Z10_ST10_11_00:

REST UNIT - P001_Z10_ST10_16_00:

REST UNIT - P001_Z10_ST10_17_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_18_00:

REST UNIT - P001_Z10_ST10_23_00:

SWIVEL CLAMP UNIT - P001_Z10_ST10_24_00:

REST UNIT - P001_Z10_ST10_25_00:

CONCLUSION:

2D drawing for each clamp units with all child parts and also create child part drawing for the same for the fixture assembly created in challenge 8 and 2D drawing for each pin units and rest units drawing with all child parts and also create child part drawing for the same for the fixture assembly created in challenge 8 has been done.