Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

Creating Tooling axis

we created tooling axis by point and direction 

also we modified class A surface , the above one is modified class A surface

After that we did the draft analysis for class A 

after that we created class B surface 

after that we created class C surface

after that we joined this with class A surface 

we trim join with class B suface

Finaly we get output just for that we applied close surface and get closed body

after that we did the draft analysis for close body

after that we crated locators as you show in image in challenge box

after that we give the draft for tham 0.5degree is draft angal

after that we added together to main body

after that we created one Heat Stakes along ribs and translated with point to piont with paste special

after that we added to main body

after that we did the draft analysis for heatstakes and locators

completed design in various orientations (Isometric, Front, Side, and Top View)