Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

REPORT:

• SELECT THE FLATE PLANE AND CREATE A TOOLING AXIS AND CREATE A POINT OVER THE SURFACE MIDDLE AND CREATE A LINE ON THE POINT AND FIX IT AS A TOOLING AXIS.
• THE DRAFT ANALYSIS IS DONE USING THE MAIN TOOLING AXIS.

• FIRSTLY, B SURFACE TO BE CREATED WITH 2.5mm OFSET AND SOME FILLETS WILL BE DELETED AND IT IS FILLED WITH MULTIPLE EXTRACTS MAKE IT AS TWO SURAFAE FOR EACH GAP AND CREATE A BOUNDARY AND EXTRAPULATE IT AND TRIM IT.
• FILLETS ARE TO BE GIVEN AT THE EDGES.

• SECONDLY, BY SELECTING THE BOUNDARIES OF THE A SURFACE AND SWEEPING THE AREA WITH REFERENCE TO THE AXIS.
• THIRDLY, BY JOINING CLASS A AND CLASS C AND THEN INTERSECTING THOSE WITH B SURFACE AND THE OPEN BOUNDARY SHOULD BE EXRAPULATED ON THE B SURFACE.

• FINALLY, TRIMMING A+C AND B IN THE CLOSED BODY IS GETTABLE.
• THEN USING A CLOSE SURFACE IN PART BODY, THE SURFACE WILL BE CONVERTED AS SOLID.
• THEN HEAT STAKES IS CREATED ON THE POINT GIVEN WITH CLASS A, MAKE A POSITIONED SKETCH IN A GIVEN POINT AND DRAW 2 CIRCLES AND PAD IT AND THE RIBS TO BE DRAWN AND DRAFTS AND FILLETS TO BE DONE.
• IT IS UNION TRIMMED WITH THE PART BODY AND THE 4-WAY LOCATORS SHOULD BE DRAWN.
• DRAW THE LOCATOR ABD PAD IT THE CHAMFER AND THE DRAFT 0.5 IS GIVEN AND FILLETS ARE GIVEN.
• FINALLY, UNION TRIM WITH THE PART BODY AND CHECK THE DRAFT ANALYSIS WITH 0.45 AS LIMITT.