Usage of Navigation tool , Timeliner and Clash Detection test using Naviswork
Q.1
Aim: To save the structural and architectural file to NWC
Step by step procedure as follow:
Open Revit software
Click on Open>Select project 7 file>Select Architectural Model file
Go to file>Select Export>Select NWC file and export this file into navisworks
Select destination folder to save this file and ok
Click on Open>Select project 7 file>Select Architectural Model file
Go to file>Select Export>Select NWC file and export this file into navisworks
Select destination folder to save this file and ok
Q.2
Aim: Using the navigate tool walk through model
Step by step procedure as follow:
After open the file with the help of scrolling go to reception area
Now Fo to Viewpoint>Select Save viewpoint>Rename it as Reception area
In viewoint seelct record and then click on Walk option
Now start walking through reception area by using mouse cursor
After recording click on STOP and name it as Reception area
Now Go to Animation and play the just recorded video
in Animation select Export option to export this video
Q.3
Aim: To use navigate tool to use realism feature to walk through model
Step by step procedure as follow:
After open the file with the help of scrolling go to room
Now Fo to Viewpoint>Select Save viewpoint>Rename it as
In viewpoint select Realism>Select third person
Now select Record option and select walk option to go through model
After recording click on STOP and name it asOffice room
Now Go to Animation and play the just recorded video
In Anomation select Export>to export this video
Q.4
Aim: To embed both architectural and structural NWC file to navisworks file
Step by step procedure as follow:
As we already open Architectual file in Naviswork
In Home tab Select Append>Append>Add Structural file>Open
In Home tab select>Clash detection test
Add test and rename it as Demo test, in section A select architecture and section B structural file
Now select Run Test
If there is clashes then it will shows the total no. of clashes and there is option to select one by one clash and set it is Active mode or Reviewd or Approved.
Q.5
Aim: To using timeliner feature in naviswork prepare a schedule for the project and add start date and end date also actual start date and end date
Step by step procedure as follow:
Open Naviswork software and load Architecture file
In Home tab select>Timeliner
Click on Add task and add all the tasks with a planned start, planned end, actual start, and actual end dates
Add according to assigments
Add task as Construct type, In selection tree select that particular that we are just added and then select Attech option and select current
Now Go to Stimulate option and play the video
Now in right hand side Select Export option
Save it in appropriate folder