Tool Test 1

AIM

To check the geometrical errors and take midsurface of the model, and do the meshing on the midsurface with the given quality parameters and assign thickness to the mid surface

PROCEDURE

1. Import the model
2. give cons resolution ,length is 1
3. Orient the components to one direction
4. perform TOPO
5. Check geometry
6. Clear geometrical errors
7. Check thickness of the components by using measure option
8. Extract the midsurface ,For uniform thickness use offset ,for varying thickness use middle
9. Provide the target element length,i.e minimumlength,max length and average
10. give quality parameters
11. split the faces into smaller areas
12. mesh the component
13. use best option fot mehing,smooth,split and reconstruct for better mesh flow
14. check quality errors and clear them
15. Assign proper thickness after meshing
16. Release the FE from geometry