Stock Bracket Assembly

PROCEDURE REPORT - Stock Bracket

1. Top down approach is followed here.
   
2. An assembly design window is opened and a new part is added.
3. The sketch of a part is created and then the part itself is created using pad, pocket, etc.
4. The same procedure is followed for all 8parts.
5. All 8 parts are individually saved. This can be done using save management also.
6. One part is used 4 times, so the saved part is again inserted thus creating copies to be used.
7. Using contact, coincidence, offset and angle constraints; all the parts are assembled as per the drawing.
8. Using ‘Scene’, and exploded view is created and captured.
9. A drawing of the front, top, isometric and isometric exploded view is created with the BOM.

Image of part - 1 - STOCK SUPPORT BASE:

Image of part - 2 - STOCK SUPPORT ROLLER:

Image of part - 3 - ADJUSTING SCREW NUT :

Image of part - 4 - SUPPORT ROLLER BRACKET:

Image of part - 5 - ADJUSTING SCREW GUIDE:

Image of part - 6 - ADJUSTING NUT HANDLE:

Image of part - 7 - SUPPORT ADJUSTING SCREW:

Image of part - 8 - THRUST BEARING:

Image of the assembly :

Image of exploded view: