Project 2 - Development of TFT Cluster Speedometer Software Component

Aim:

To develop Cluster Instrument receives the signals from other ECU via CAN bus interface. It also receives commands from the driver via steering wheel buttons. The signals are then processed by the Cluster ECU, after which the Cluster ECU may send the vehicle information to the LCD or light the LEDs and so forth, according to the results. Therefore, the Cluster ECU can be viewed as a carrier of the information flow

solution

TFT Cluster Speedmeter is developed using MATLAB/Simulink using the requirement shown below

Requirements:

1.1 Calculating TFT Display Speed

Average Vehicle Speed would be displayed only if its between 2 kmph & 250 kmph. Any value outside this range will be discarded by its lower limit & upper limit.When Average Vehicle Speed is < 2 xss=removed xss=removed> 250 kmph, DisplaySpeed = 250 kmph

1.2 Main Data Filtering

Main Data Filtering subsystem will be activated for every 10th millisecond.DisplaySpeed1 (t) = ((DisplaySpeed (t) x 0.65)/ Main Filter Speed Value) 0.05

1.3 Auxiliary Data Filtering

Auxiliary Data Filtering subsystem will be activated for every 10th millisecond,DisplaySpeed_Filter (t) = ((DisplaySpeed1 (t) x 0.78)/ Auxillary Filter Speed Value) - 0.03

1.4 TFT Speed Output

If |(DisplaySpeedFilter - DisplaySpeed)| > 1.5

{

Vehicle Speed Display = DisplaySpeed

}

else

{

Vehicle Speed Display = DisplaySpeed Filter

}

SLDD file tagging

simulink data dictionaryfile

Requirement tagging1

Requirement tagging2

Requirement tagging3

Requirement tagging4

Model advisor JMAAB checking

Fixed point tool report

Applied the corresponding data types

Checked the SLDVDesign error report

report attached as TFT_speedometer_reportSLDV

 MIL testing shoen below