Project 2_Creating a 3D rendered model for a Residential Building in AutoCad

Aim & Introduction : My aim is to make moidel of 2 floor building using commands like rectangle poly lines, extrude, press pull, subtract, sweep, block,

First of set units, limits & zom all. Make layer for different elements of building. Make 2d plan of building in top plane with poly line & extrude upto slab bottom excluding door & window portion. Now extrude the wall upto sill level. Now make rectangles of wall above window & door top & extrude upto window or door width. Make rectangle for floor pcc in top plane & extrude below for pcc thickness. Make another rectangle in top plane for floor tile & extrude above pcc. Make rectangles for window & toilet ventilator projection in top plane & extrude it as per window size, make it block & insert it at window & ventilator locations. Make plan of window, main door, bed room doors & ventilator in top plan. Now extrude verticle potion upto indivudial heights now shape of horizontal member , for glass of window make rectangle of below horizontal member, for door & window shutter make the same way extrude it. Now make block of door, ventilaor & window & insert as per location. For stair case make section of stair case in top plane rotate it to vertically & etrude width of staircase & place it staircase portion. Make rectangle for slab portion in top plane & move it vertically upto 3.00mtr height & make rectangle for staircase & subtract it from main slab. Now make block of whole building place it on first floor. now make walls for staircase headroom & extrude it. Make rectangle for staircase headroom.