Project 1 - Meshing of Floor Panel

OBJECTIVE:

To do good mesh after mid surfacing the parent geometry.

PROCEDURE:

Take the cad model.

check the geometry for any errors like triple cons,sharp edges,missing faces,etc

if there any geometry errors try to autofix it, if didn't work go manually

check the thickness of the model

create mid surface with offset command or any other procedure

after getting mid, clean geometry where there should be no distance less than minimum

try to clean up complex areas into smoothy ones

input quality criteria

do mesh area by area and check there is no quality fails, if there fix it using split,smooth,reconstruct,etc with these commands

finally you will get good mesh flow

RESULTS AND FINAL IMAGES:

added the images below and submitted the drive link of pro 1