Project 1 - Meshing of Floor Panel

Objective: - To create mid surface and good mesh flow.

Procedure: - Geometry Clean-up use tool like release cons and delete extra hot point Remove single cons in given cad model and after that topo.

After that create auto mid surface generation have used method skin option in mid surface and offset method use in some part.

After that clean-up of geometry do the required cut and join in mid surface. And delete unwanted hot points.

MESH: -

For mesh generation have used best option in mesh and for good mesh flow have used tool like reconstruction, smooth and collapse in shell mesh. And also used split, swap, and join option in element.

Learning Outcomes: - This geometry is good for learning. Lot of challenge in geometry clean-up.