Project 1 : CFD Meshing for Tesla Cyber Truck

Introduction

ANSA is a preprocessing tool an interface between the designer(CAD) and the FE model. WE have different modes in this tool such as Topo,Classic mesh, Volumetric mesh, Solver Decks and Morphs.

In any model in ANSA the initial step would be the geometry clean-up i.e. removing the overlapped and unwanted surfaces i.e. removal of all the existing single cons and triple cons and other extra surfaces which are not attached to the component but still exist in the model.

Basically at the final clean-up only double-cons have to be present.

The main objective and the other procedure steps, tools ,meshing and wind tunnel creation are attached in the document below.