Project 1

AIM: To create the mould blocks for the respective models and provide the slider where ever needed and to provide the cooling channels and the ejector bins for the model.

DESCRIPTION: 

step 1 : first use the draft analysis command to check the core and cavity region and then whether adequate draft is provided.

step 2 :after analysing the draft provide parting line to the respective model. 

step 3: after parting line check whether the mould is seperable into a core and cavity surfaces or else use shutoff surfaces to fill the holes where ever needed to make mould seperable.

step4 ; if the component is needed slider then insert the component into assembly to seperately to create core and cavity blocks to accomade the sliders and washer in it. add material and subract the material to get the actual profile of the slider'

step5: after creating the slider analyse whether insert is neccessary. orelse go with the normal profile of the component.after this provide the ejector pins in the area where the ejection of the component is complicated. after this provide cooling channels to safe guard the component fram shrinkage and then warpage problems. scale is measured to material properties to save the component from shrinkage.