Project 1

(submitted by Kurias.M.George)

OBJECTIVE

For the given component, check for the geometrical errors and mesh with the given element Quality criteria. After meshing the component the thickness has to be assigned.

Write a detailed report on your meshing process and also mention which method you used to extract the mid-surface along with the reason.

METHODOLOGY

• Initially you check for the geometry orientation. Then we go for geometry check. We adjust the orientation using faces--->orient
• Then we go for the topological errors in the model. We edit it using the cut tool
• Fine tool under the auxiliaries is used to manage the shape
• We do a overall topo.
• Then We create a mid-surface for the meshing.
• Then we go meshing on the mid surface with the given requirements. We apply the Quality criteria and meshing parameters.
• Then we go for meshing properly.

METHOD FOR MID-SURFACING

• Generate an offset with half the thickness of the body,offset,middle was the method used for the mid surfacing.
• upper and bottom portion were analysed properly for the mid surface generation
• Then the mid surface is generated.
• Then the mid surface isolated using the !knot operator.

MESHING

• Initially the Quality criteria and the mesh parameters are given in the challenge,we enter the values accordingly.
• Then we mesh the mid-surface area, part by part
• After the meshing we analyse the mesh by checking for the off elements.

RESULTS

• The mesh for the model is obtained according the quality criteria
• Shell quads were estimated as 40381.
• Total 42387 mesh was obtained
• 104 off elements were seen as that was due to edge geometry errors.

LEARNING OUTCOMES

Learned to mesh a component by taking its mid-surface. Learned to eliminate the off elements. Learned to mesh properly.

CONCLUSION

For the given component, the geometrical errors were analysed and meshed with the given element Quality criteria . After meshing the component ,the thickness is assigned.