Project 1

Project !

Aim:Route the Wiring harness on Given Engine and Prepare flatten view drawing in CATIA V5. Application of all packaging rules, Industry best practices studied in this course shall be demonstrated in design. Apply Protection coverings as required.

Proper routing of bundle

Report writing

Flattening and Drawing creation

Electrical definition and Catalogue creation

All the components used in the project are defined electrically and catalogued.

L clip

12 Pin connector

Cavity clip

Channel Bottom

Channel Top

2 Pin Connector

P Clamp

Proper routing of bundle

This harness routing is done for the V26 engine.

Flattening and Drawing creation

Note: I was not able to exact few components such as the COT tubes,fir tree clips, P Clamps, Channelsm and also few connectors in the Electrical Harness Flattening Workbench. While enquiring with the SKILL LYNC mentors, they assured me that it was a software issue and helped me with the project.

All the required files are attached as per requirement.