Problem Set-1 c Week 11Challenge : Transient Handling

*

*ATTACHED A FILE

1. Objective: To extract the mid surface and clean up the geometry on the given component. To generate mesh on the given component with low tria concentration and proper mesh flow. To assign the thickness for the given component.      2 Extraction of Mid- surface: During the mid surface extraction,…

Aim: To create the shell (2-D) meshing for the Car Side Door Panel by eliminating geometrical errors and considering the given element quality criteria using Hypermesh Introduction: 1. Car Side Door Panel The side door panel is the plastic part. materials used for the door panel are acrylonitrile-butadiene-styrene…

Target: 1)To Generate tetra and hexa mesh on given component with in the critriea given  Target size  5mm Tet Collapse 0.15 Hex size 10mm 1.1) Modal Input                 1.2)To Generate 3D mesh on The Given Housing model And to check for The Tet collapse and quality.…

                                                               SIDE POLE CRASH SIMULATION OF DODGE NEON CAR                …

Frontal Crash SimulationOBJECTIVE: Simulate a Frontal car crash simulation of Dodge Neon BIW using RADIOSS solver and Preprocessing using HyperMesh / HyperCrash. To perform the crash analysis on the frontal section of the car and to check where the stresses are acting on it. To check the unit systems and change…

Objective: To simulate a crush tube with different notch patterns and contact interface and come up with a concise report on how it affects  Internal energy, simulation time, plastic train, simulation time. Modal discussion: 1)The crush tube has two segments upper body and the lower body in between them notches are…

Target: To Run Crash Beam file with Default Element Formulation and Optimized Element Formulation Run a Comparative Study on Energy Balance and Mass Addition, Hour Glass, Contact Energy PROCEDURE: Importing File into Radios: Select IMPORT SOLVER DECK>S to select the radioss file of the previous loaded assignment >…